Marvel 15CM Specifications download pdf (Page 7)

INSTALLING THE ICE MACHINE WATER SUPPLY

Figure 6

Back view of

ice machine

Water supply

inlet

Water Supply

Observe and follow all local building codes when installing this

appliance.

Aach the supplied water line adapter (Figure 7) to the water

valve inlet on the back of the ice machine (See Figure 6). Be sure

the rubber washer is in place in the inlet valve nut. Bend the

1/4” copper tubing to suit your installaon being sure not to kink

the tubing. Use 1/4” copper tubing for your water supply which

is available at any local hardware or plumbing supply store.

When installing a water line for this unit a shuto valve is recom-

mended. NOTE: DO NOT USE A SELF-PIERCING TYPE VALVE.

The water line ng supplied with your ice maker is to be used

on a 1/4 inch copper water supply line only. Do not aach a plas-

c supply line to your unit with this ng.

Water pressure must be at a minimum of 20 psi for proper op-

eraon and a maximum of 120 psi.

Make certain all water connecons are waterght aer instal-

laon. Form the tubing so that it will not vibrate against the

cabinet body or kink when your ice machine is set in posion.

NOTE

Rubber Washer

Adapter

Valve Fing

Compression Fing

Compression Nut

1/4 Diameter Copper water supply

line (supplied by customer)

From water supply

to ice maker

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Marvel 15CM Specifications Page 7